Condition: The output signal of the transmitter is 0-10V, the corresponding temperature is -100--200 degrees Celsius; the analog input range of CP1H is set to 0-10V, and the resolution is 6000.
With the improvement of people's quality of life, people's lifestyles have also become varied. Different kinds of recreational products are starting to appear in people's lives, such as electronic cigarettes. The emergence of e-cigarettes represents a part of young people's thinking and means that electronic products are beginning to show a trend towards diversity.
simply replace the pods. The Pod system uses an integrated pod rather than a tank for higher nicotine strength and provides low power traction. the Pod system is rechargeable and has a longer life and higher battery capacity than disposable electronic cigarettes.
Our company Pod system has a built-in 380mAh battery and a USB charging port on the bottom. In comparison, the Pod system has a built-in battery of only 180mAh, but the Pod system charges much faster.
Our electronic cigarettes are of rechargeable construction. The first time you use the charger to charge, it is recommended to use up the remaining power before filling up, this is to ensure the performance of the battery.
Vape Pod System Oem,Vape Pod Oem,Close Pod Oem,Thc Pod Disposable Shenzhen MASON VAP Technology Co., Ltd. , https://www.e-cigarettefactory.com
Purpose: Use the SCL2 instruction to scale the 0-6000 (BIN) of the analog converted data to the -100--200 (BCD) Celsius display output.
The procedure is as follows:
SCL2 control word interpretation:
200: Analog input channel 1 of CP1H
D100: Offset (signed BIN) as shown in the figure below
D101: ΔX (signed BIN) is shown in the figure below.
D102: ΔY (BCD) see the following figure
D200: Conversion result channel
Result: 0-6000 (BIN) conversion to -100--200 (BCD) Celsius display can be achieved after the program is executed.
Note: Because the BCD number is expressed in hexadecimal data, the corresponding temperature value should be monitored in hexadecimal. For example, when the data in the 200CH is &4000 (ie 6.66V voltage input), the data D200 should be displayed in hexadecimal.
The & symbol indicates a decimal number; # indicates a hexadecimal number.
